JF MIX 4000 CS Manual De Instrucciones página 23

A c c o r d i n g t o t h e M a n u f a c t u r e r, i t i s
recommended that the angle when the cardan
is functioning can reach maximum 35º for a very
short time. When work is continuous, it cannot
go over 15º.
15
o
In normal working conditions, with the
implement in its horizontal position and being
shifted in a straight line, the contact surface
between the tube and the shaft bar must be 2/3
of the minimum length of the cardan.
In a more critic situation, the measure of this
overlap must be at least 1/3 of the minimum
length of the cardan.
Always turn off the PTO when you maneuver
with the machine coupled.
Never use the cardan without its
protective cover. Tie long hair and do
not wear loose-fitting clothes when
you operate the machine.
Contact with the cardan in operation
might result in a serious accident.
L
2/3 de L
1/3 de L
CAUTION!
Instructions Manual
AFTER CUTTING
Using a file, remove all the filings
from the tubes. Clean and lubricate
with a thin layer of grease.
Keep the flanges aligned.
W h e n a s s e m b l i n g t h e P T O
driveline shaft assembly, one
should carefully observe that the
cardan yokes on the extremities
are aligned in the same position.
Incorrect alignment of the yokes
will cause vibration, premature
wear and breakage.
ƒ Right
ƒ Wrong
ƒ You must observe the length of
the cardan shaft whenever you
use a different tractor model.
ƒ Clean and lubricate the PTO
axis (from the tractor and the
machine) before you couple
the cardan.
ƒ After you mount the cardan,
fasten the safety chains on
the tractor and the machine,
leaving a clearance to allow
the articulation of the cardan
assembly in any working
conditions.
ƒ It is the Authorized Dealer
sole responsibility to perform
the cardan shaft preparation
and the first activation of the
machine.
23