JF MIX 4000 CS Manual De Instrucciones página 35

7.
Loosen the nut (F), using a 50mm
screwdriver.
8.
Using a 22mm socket wrench, with a
minimum length of 110mm (to reach the
nut), remove the nut (G) and the bolt (H).
9.
Pull the sensor (J) forward carefully.
10.
In order to assemble the new load sensor,
use the same procedure above, in reverse
order.
IMPORTANT!
w
hen you assemble a new sensor
you do so in The righT posiTion
The weighing sysTem will noT work properly
a
ssemble in such a way The wire from The sensor
is posiTioned as indicaTed in The picTure below
Right
,
make sure
;
oTherwise
.
.
Wrong
Instructions Manual
F
G
J
H
35