Supply - JF MIX 4000 CS Manual De Instrucciones

SUPPLY

The Wagon's supply with salt and concentrate
should be done with the rotor mixer in
operation.
1.
First, remove the lock bolt (B) from the cover.
2.
Open the cover by activating the hydraulic
piston (A).hidráulico (A)
If you open the cover without removing
the lock bolt (B), you will seriously
damage the piston and the cover.
Before you lift the canvas cover, make
sure there are no obstacles that might
collide with it, such as trees, wires etc.
Be extra cautions about the power grid.
3.
Activate the PTO at 540rpm and keep the
rotor mixer rotating.
4.
Start the supply by unloading the products
inside the mixing chamber.
5.
After you finish the supply, activate the levers
from the tractor's remote control and lower
the canvas cover from the Wagon.
NOTE!
The rear grid might be used for supply or
addition of products in the mixture.
You can verify the mixture in the mixing
chamber from the driving position or even
through the protection grid at the back. (Check
the picture beside).
ATTENTION!
CAUTION!
Instructions Manual
CUBIERTA
B
LOADING GRID
A
27