Connecting The Hoses; Removing The Hoses - JF MIX 4000 CS Manual De Instrucciones

CONNECTING THE HOSES

Connect the four hydraulic hoses onto the
valves from your tractor's remote control. Two
for the activation of the hydraulic cylinder and
the other two are connected to the hydraulic
component (to activate the hydraulic engine
from the discharge screw and to open/close the
discharge door).
1.
Remove the protective caps (A) from valves
and hoses.
2.
Couple the hoses onto the valves from the
tractor's remote control, pushing firmly.
Bleeding the system: in order to eliminate the
existing air in the hoses and cylinders, when the
hoses are connected to the valves, activate the
respective levers from the remote control several
times, both ways, until the end of its course.

REMOVING THE HOSES

1.
In order to unplug the hydraulic hoses, it
is necessary to relieve the pressure of the
system. Therefore, turn off the tractor, and
then activate the levers some times, relieving
the system.
2.
With the control levers in neutral position,
pull the hoses rapidly: the disconnection will
occur with minimum oil loss.
3.
Then, replace all the protective covers (A) on
the hoses and tractor valves.
24
Instructions Manual
A