Weekly Table; Week Day; Day Bin Zero Calibration; Day Bin Weight-Calibration - Roxell RDC Manual Del Usuario

Weekly Table

In the following 7 screens we can setup the each day of the week if it is a feed or fast day.
Set 0 for fast day, 1 for feed day. The text display to the right of this number shows On
when the number entered is 1 and Off when the number entered is 0.
Use the Forward back arrows
as a feed or fast day.

Week Day

Set up here the current week day.
Use numbers between 1 to 7 for the weekdays: 1= Monday, 2= Tuesday, 3= Wednesday,
4= Thursday, 5= Friday, 6= Saturday and 7= Sunday.

Day Bin Zero Calibration

This screen is used to Zero calibrate (tare) the day-bin. It displays the day-bin weight in
the bottom row and the time in seconds that is left until the end of the calibration in the
upper row. Enter 0 in the day-bin weight to start the Zero Calibration.
The calibration takes 1 minute. At the end of the calibration, the weight display shows 0.

The Zero calibration has to be done to tare the day-bin weight or before Weight-
Calibration is done.

Day Bin Weight-Calibration

This screen is used to calibrate the day-bin with a known weight. It displays the day-bin
weight in the bottom row and the time in seconds that is left until the end of the
calibration and the known weight in Kg (Lb) in the top row (the time is displayed on the
left). Enter the current day bin weight in Kg (Lb) to start the weight calibration. The
calibration takes 1 minute. At the end of the calibration, the weight display shows the
current bin weight

The accuracy of the Weight-Calibration has a direct affect on the accuracy of the day
bin weighing.
Roxell Daybin Controller – RDC
Week Table [0,1]
Monday 1 On
to scroll through the weekdays and setup each day
Week Day [1-7]
1 Monday
DayBin 59 Sec
Cal-Zero
DayBin 0 500.0
Cal-Weight
Page 15 of 193
0
500