Programs; Timed Blast Chill Cycle; Modify Timed Blast Chill Setpoint - Angelo Po 3166220 Manual De Uso

- I
-
I
- I
With machine at rest,
Push up button to select timed blast chill cycle.
The cycle time setpoint is visualised, the blast chill led is illuminated fixed.
Push the on/sby/enter button to start the cycle. The blast chill led remains illuminated
fixed.
Push up button to select timed blast chill cycle.
The cycle time setpoint is visualised, the blast chill led is illuminated fixed.
Push up button for 3 seconds to enter into the parameter modification mode.
On the display the cycle time setpoint values and the blast chill led begin to flash.
Uitilise the up and down buttons to modify the flashing
Push the on/sby/enter button to confirm the new value or, alternatively, wait 3 seconds
for its
The cycle time setpoint is visualised in a fixed mode, the blast chill led is illuminated
fixed, while the buzzer signals the event by way of the emission of 3 short consecutive
beeps
Push the on/sby/enter button to start the cycle. The blast chill led remains illuminated
fixed.
During the execution of the cycle the display visualises the residual cycle time: it is always possible to
visualise the temperature of the chamber probe for 5 seconds pushing the
The end of the cycle is signalled acoustically by the card by way of 5 long consecutive beeps with automatic
passage to the conservation phase. In conservation on the display the chamber probe temperature is
visualised.
If the cycle is stopped manually the passage to the conservation phase does not come about and the blast
chill led is lit flashing.
N S T R U C T
N S T R U C T
N S T R U
C T
OPERATION

PROGRAMS

TIMED BLAST CHILL CYCLE

MODIFY TIMED BLAST CHILL SETPOINT

acquisition.
.
I O N M A N U
I O N M A N U
I O N M A N
A
L -
A L -
U A L -
CHAPTER 3
value.
button.
7