Publicidad
130524
2. Checking the contour of a sewing pattern
WARNING :
• Make sure without fail of the contour of the sewing pattern after selection of the sewing pattern.
• Do not depress the start switch while confi rming the pattern shape. If you depress it, the sewing
3. Sewing
1) Set a workpiece on the feeding frame section.
2) Depress the pedal A, the feeding frame will come down. If depressing the pedal again, the feeding frame
will go up.
3) Depress the pedal B, and the sewing machine will start sewing.
4) After the sewing machine completes the sewing, the feeding frame will return to the home place, and go up.
To carry out sewing, two conditions have to be satisfi ed, i.e., "heat cutter has no fault" and
"safety cover is closed". If the sewing machine is not able to perform sewing, check the
aforementioned two conditions.
Refer to the Instruction Manual for the sewing machine for additional information.
If the sewing pattern extends outside the work clamp feet, the needle will interfere with the work
clamp feet during sewing, causing dangerous troubles including needle breakage.
machine will start sewing.
B
A
Feeding frame
1) Depress the feeding frame switch to its fi rst step
to lower the feeding frame.
2) Every press on the
frame will move by one stitch. Keeping the key
held pressed, the feeding frame will move con-
tinuously.
3) If the
key is pressed, the needle point will
return to the starting position, and the feeding
frame will go up.
If the feed is fed by one stitch, detach
your foot from the pedal.
B
A
Start
– 8 –
or
key, the feeding
End of sewing
Publicidad
Capítulos
