Checking The Contour Of A Sewing Pattern - JUKI LK-1941 Manual De Instrucciones

20130424 LK-1941,1942 R08
(6) Finish of setting

2.Checking the contour of a sewing pattern

WARNING :
• Make sure without fail of the contour of the sewing pattern after selection of the sewing pattern.
If the sewing pattern extends outside the work clamp feet, the needle will interfere with the work
clamp feet during sewing, causing dangerous troubles including needle breakage.
• When checking the sewing pattern, do not depress the pedal switch up to the second step.
Sewing starts if the pedal switch is depressed up the second step.
1) Press the
2) The feeding frame comes down and moves. Then,
after it has been raised, the sewing LED lights up,
and the sewing is ready.
※ If the
SEWING
the set value of the respective items again.
1) Depress the pedal switch to the first step to descend
the feeding frame.
2) Every press on the
frame will move by one stitch. Keeping the key held
pressed, the feeding frame will move continuously.
3) If the
to the starting position, and the feeding frame will
go up.
key.
key is pressed, you can make sure
Use after checking the pattern No.
Press the sewing ready switch while
No. other than the service pattern is
indicated on the display, and the error
No. E-1 will be shown.
At this time, set again the pattern No.
which has been registered.
or
key is pressed, the needle point will return
If the feed is fed by one stitch, detach
your foot from the pedal.
key, the feeding
27