Starting Up - IKUSI TM70 Serie Manual De Instalación Y De Utilización

5.3 - STARTING UP

Proceed with caution; the equipment may not be connected correctly which may lead to
unforeseeable movements on starting-up.
Once the receiver has been connected, disconnect the power supply to the motors, (for example,
by removing the fuses) and power on the receiver. First of all the LEDs will light on an instant to test
that all are all right, after this the receiver will enter into a 'SCANNING' mode and the following
LED's will be lit in the receiver;
POWER (1):
HARDOK (2):
SIGNAL (3):
DATA (4):
ID (5):
CAN_RUN (6):
CAN_ERR (7):
ORDER (8):
RELAY (9):
1.- Label for crane identification.
Optional: LCD Display.
2.- LED.
3.- Manoeuvre button.
4.- Contact key.
5.- Start button.
6.- STOP button.
7.- Option: Range Limitation.
TM70Bi V4.1 (03/12) 1121174.pdf
IKUSI reserves the right to modify this information without prior notification.
ON, indicates that the power supply is correct.
ON, indicates the absence of faults on the boards.
OFF, in the case of the channels being signal free. Blinks ON when
there is a RF signal on the channels.
OFF, when there is not another TM70 system active in the area. Blinks
ON in the opposite case.
OFF
ON, Indicates that CAN communications with expansion boards are OK.
OFF
OFF
OFF
Figure 5. Signalling LEDs in the receiver.
Figure 6. Command and signalling elements in the transmitter
9