Maintenance; Warranty; Precautions; Troubleshooting - IKUSI TM70 Serie Manual De Instalación Y De Utilización

7.- MAINTENANCE

7.1.- WARRANTY

IKUSI guarantees the TM70 remote control sets for a period of up to one year after the date of
delivery. This guarantee covers repairs and the replacement of defective pieces at our Technical
Service Department. Both the transmitter and receiver will be necessary if any repairs or
replacements need to be carried out.
The guarantee does not cover damage resulting from the following:
 Transport.
 Incorrect installation.
 Repairs or alterations made to the equipment by personnel other than from IKUSI.
 Obvious misuse or incorrect maintenance of the equipment.
Our Technical Service reserves the right to evaluate breakdowns and damage.
Under no circumstances will IKUSI be held responsible for hold-ups at work, accidents or expenses
incurred as a result of equipment malfunctioning.

7.2.- PRECAUTIONS

This equipment is designed for use in an industrial environment. However, we recommend you
follow the instructions below to extend the life span of your remote control set:
 Use the belt provided with the transmitter to prevent the transmitter from falling.
 Do not clean the transmitter with solvents or pressurised water. Use a damp cloth or soft
brush.
 Use and recharge the battery regularly.
 Check every day that the STOP pushbutton is working.
 Disconnect the receiver cables if soldering/welding work is going to be carried out on the
crane.
 Periodically check the condition of the transmitter rubber seals. Change these over if they
show signs of deterioration to ensure they remain watertight.
 Clean the battery contacts.

7.3 - TROUBLESHOOTING

The transmitter and receiver have status monitoring LED's, which help to identify irregularities. The
most common signals are contained in the tables below:
TRANSMITTER
Solid green
Green pulses.
Red slow flashing
Red fast flashing
Red double flashing
Solid red
TM70Bi V4.1 (03/12) 1121174.pdf
IKUSI reserves the right to modify this information without prior notification.
LED
Transmitter transmitting normally. OPERATION mode.
Transmitter ready for start-up. STAND BY mode.
Battery level low
Probably, EEPROM module is not plugged in.
Transmitter cannot start up because a manoeuvre command is
present.
Transmitter failure
MEANS
12