Annex B.- Programming The Machine Identification In Lcd Transmitters - IKUSI TM70 Serie Manual De Instalación Y De Utilización

ANNEX B.- PROGRAMMING THE MACHINE IDENTIFICATION IN LCD TRANSMITTERS.

Transmitters with the LCD display option allow the operator to programme a machine identification label
of up to 24 text characters. This identification is displayed on transmitter starting-up.
This text must identify the machine with a name that is commonly known by the workmen. When first
starting the transmitter you can edit/introduce this text as follows:
1. Introduce a battery and turn the ON/OFF key to ON.
2. Push in and then extract the STOP button and you
will observe the LED pulse orange-green.
3. Press pushbutton 4 followed by START button and
keep both pressed together during 3-4 seconds and
then you will enter the "CONFIG MODE". Press
pushbutton 4. (press TWICE pushbutton 4 if it only
appears the option "CONFIG MODE").
4. Move through the menu with pushbuttons 1 and 2
until reaching the EDIT LABEL menu. Press push
button 4.
5. Once you have entered into EDITING mode, there
appears in the display the text "CRANE ??" in which
the first character blinks. From this point you can
edit the name of the machine by means of the push
buttons 1 to 4, whose functions are described as
follows:
 Pushbutton 1:
 Pushbutton 2:
 Pushbutton 3:
 Pushbutton 4:
one, (towards the right hand)
6. Push START to store the edited text. LCD will show the message "SAVED" for 2 seconds.
7. You exit the EDITING mode by pressing the STOP.
TM70Bi V4.1 (03/12) 1121174.pdf
IKUSI reserves the right to modify this information without prior notification.
To move for the list of established characters in descending order.
To move for the list of characters established in ascending order.
To return to the previous character in the display.
To validate the published character and move to the
LCD
LCD
following
16