Introduction; Calibration Of The Analogue Feedback With Lcd Display - IKUSI TM70 Serie Manual De Instalación Y De Utilización

TM70 – ANALOGUE FEEDBACK / IN 0-10v OPTION / CALIBRATION

14.1 - INTRODUCTION

Systems with analogue feedback need to have the options Display and Analogue Feedback.
Systems with analogue feedback need at startup the calibration of the analogue input by the
distributor or the user. The following steps need to be done:

14.2 - CALIBRATION OF THE ANALOGUE FEEDBACK WITH LCD DISPLAY

Transmitters with display option, allow the operator the calibration of the analogue input through the
edition of a three digit value plus a comma and a measurement unit up to three characters.
The modified feedback calibration data will not be updated in the receiver EEPROM. In
order to do it, please copy the new information located in the transmitter EEPROM into
the receiver one.
At the remote control start up the Calibration must be done as follows:
1. Insert a fully charged battery and turn ON the
contact key.
2. Push and Pull the STOP pushbutton. An
orange blink will be seen on the LED followed
by green pulses.
3. Place a known load on the crane in order to
introduce the First value in Calibration mode.
4. Switch off the remote control and start the
system entering in CALIBRATION mode. In
order to do so, it is necessary to do the
following:
5. Press push button number 4 up to second
speed and
pushbuttons pushed for a couple of seconds
until it appears on the display CONFIG mode.
6. Press the push button number 4 to go inside the
MENU.
7. To move through the menu, use pushbuttons 1 & 2 until CALIBRATION menu is reached.
8. Press pushbutton 4.
9. Once we are in CALIBRATION mode, we enter a submenu where we can select the following
pressing pushbuttons 1 & 2: VALUE 1, VALUE 2, UNITS. Pressing pushbutton 4 we enter the
selected menu.
 Pushbutton 1: To move through the character list in a descending order.
 Pushbutton 2: To move through the character list in an ascending order.
 Pushbutton 3: To return to the previous character on the display.
 Pushbutton 4: To validate the edited character and move to the next character.
TM70Bi V4.1 (03/12) 1121174.pdf
IKUSI reserves the right to modify this information without prior notification.
press START. Keep both
50