Publicidad
Idiomas disponibles
Idiomas disponibles
Restore Factory Defaults (Blink Code 1-9)
Occasionally, it may be desirable to return to factory defaults . To restore factory defaults when in this mode, press the fog switch.
This will clear all user selected settings and return to the start of the setup menu (LED Code 1 Slow blink). The following settings
will be reset to factory default:
• All soft limit positions will get set to maximum .
• Position sensor "zero" values will return to the values set at the factory .
• Monitor orientation will get reset to standard position .
• Stow and Deploy positions are reset to zero degrees as established at the factory .
• Obstacle Avoidance profile data is cleared and disabled .
It is possible to abort this mode prior to activating the Fog input by simply removing power to the StreamMaster II . Alternatively,
activating the Stream command will abort this mode without restoring factory defaults and the Obstacle Avoidance Disable (Blink
Code 2-1) mode will be automatically selected .
Obstacle Avoidance Disable (Blink Code 2-1)
Pressing the Fog switch will Disable Obstacle Avoidance, clear the Obstacle Avoidance Profile and return to the start of the
setup menu (LED Code 1 Slow blink). The factory default setting for obstacle avoidance is DISABLED. Alternatively, activating the
Stream command will abort this mode without disabling obstacle avoidance and the Obstacle Avoidance Manual Operation mode
will be automatically selected .
Obstacle Avoidance Manual Operation (Blink Code 2-2)
Manual operation mode requires the operator to manually move the monitor around obstacles . When an obstacle is encountered,
movement in that direction stops until the operator moves the monitor around the obstacle . Pressing the Fog switch will select
Manual Operation for Obstacle Avoidance. Alternatively, activating the Stream command will abort this mode without selecting
Manual Operation and the Obstacle Avoidance Auto Operation mode will be automatically selected .
Obstacle Avoidance Auto Operation (Blink Code 2-3)
Auto operation mode does not require the operator to move up and down to go around an obstacle . When an obstacle is encoun-
tered, movement in that direction stops and the StreamMaster II automatically navigates up, over, and back down around the obsta-
cle as long as the joystick is maintained in the horizontal command (right or left) . Pressing the Fog switch will select Auto Opera-
tion for Obstacle Avoidance. Alternatively, activating the Stream command will abort this mode without selecting Auto Operation
and the Obstacle Avoidance Learn mode will be automatically selected .
Page 14
Publicidad
