Publicidad
Idiomas disponibles
Idiomas disponibles
Bolt Tightening Procedure
Start the tightening procedure by lubricating the nuts and bolts . Hand tighten the nuts until they are snug against the flange .
Figure 2 – Bolt Torque Order
The final torque of the bolts should be 85–90 ft-lbs . Following the correct sequential order, tighten the bolts to 30% of the final
torque . Repeat the tightening sequence to 60% of the final torque . Repeat a third time to 100% of the final torque . Finally, repeat the
sequence at the final torque .
Not recommended to mount onto a raised face flange . This may cause damage to the monitor's flange when
tightening bolts .
1
4
4
3
2
Page 5
1
7
5
3
6
8
2
Publicidad
