Publicidad
Idiomas disponibles
Idiomas disponibles
Disconnect power and disable flow before maintenance .
Keep all personnel out of the Danger Zone, in front of the outlet of the monitor when the water source is
attached . Dangerous flow velocities can cause serious injury .
Not designed for explosive environments .
Use only for firefighting by trained operators .
Ensure the thread on the nozzle swivel matches the thread on the monitor outlet . Do not over-tighten the
nozzle onto the unit .
Insufficient structural support at the inlet flange can lead to failure, which has potential to cause an injury .
Do not use monitor or nozzle as a forcible entry tool .
Ensure that the monitor is returned to the Stow position after use .
During freezing conditions, the monitor must be drained to prevent damage .
The monitor, nozzle, control box, tether controller and field adjustable stops are made for optimal
performance . Do not alter in any manner .
The monitor was designed for use with Akron nozzles . Use of any other nozzles could affect the speed
or operation of the unit and should be tested before being put into service .
Replace the identification tags if they should become worn or damaged .
The monitor uses current limiting for both the monitor and nozzle . Use only appropriate
Akron Brass Company nozzles .
Not recommended for use in salt water applications .
For use with water or standard firefighting foams only . After use with foam, flush with fresh water .
Not recommended to mount onto a raised flange . This may cause damage to the monitor's flange
when tightening bolts .
Use a nozzle of the same material as the monitor to eliminate the effects of galvanic corrosion .
Page 3
Publicidad
