Mounting Brackets; Jumper Block - Sonnet Tempo Ultra ATA66 Manual De Instalación

En

Mounting Brackets

Most drives need to be outfitted with mounting
brackets before being installed into a computer.
Please refer to your computer and/or drive's user
guides for details.

Jumper Block

Prior to installing a drive, you may need to reconfig-
ure it as either a master or slave drive. Figure 7 lists
common jumper settings. Most drives are factory
preset as a master drive. To change the setting, you
will need to reconfigure the position of the jumpers
located in the jumper block. The jumper block is
located at the rear of the drive (Figure 8), or on the
drive's exposed printed circuit board (Figure 9).
The location of the jumper block and position of
jumpers vary depending on the manufacturer of the
drive. Refer to your drive's user guide or the jumper
setting information printed on your drive.
Support Note:
drive's jumpers, verify the orientation of
the drive with respect to the illustration.
Illustrations may vary.
When configuring your
Common Drive Jumper Settings
Master Jumper selection for the primary drive of two drives
installed on the same ATA cable
Master/Single Jumper selection for the primary drive of two drives
installed on the same ATA cable (designated as only
master on some drives) / Jumper selection for a single
(primary) drive on an ATA cable.
Single Jumper selection for a single (primary) drive on an
ATA cable
Slave Jumper selection for the secondary drive of two drives
installed on the same ATA cable
Cable Select Jumper selection for special drive cable configurations;
Rarely used and not supported with the Tempo
Figure 7; Figura 7
jumper block
Figure 8; Figura 8
Figure 9; Figura 9
1-5
jumper block