Install Tempo Ultra Ata66; Close Computer; Turn On Computer - Sonnet Tempo Ultra ATA66 Manual De Instalación

En

Install Tempo Ultra ATA66

1. Select an available PCI slot to install the Tempo
and remove its access port cover (Figure 8).
2. Remove the Tempo from the anti-static
package, making sure to handle the board
by the edges.
3. Align the Tempo over the PCI slot (Figure 9).
Gently press down until it is firmly seated into
the PCI slot, taking care not to wiggle the
board as you install it into the slot.
4. Attach the host connector on the Ultra ATA66
cable to the connector closest to the bracket on
the Tempo (Figure 10); if you are unfamiliar
with the Ultra ATA66 cable connectors, see
page 1-2, Figure 1, for further information.

Close Computer

1. Carefully position the Ultra ATA66 cable inside
the computer as to avoid crimping it by the
expansion card cover. Rotate the expansion
card cover into place over the PCI slots
(Figure 11).
2. Replace the case cover onto your computer.
3. Return the computer to your computing area
and reconnect the power and peripheral cables
to the computer.

Turn On Computer

1. Turn on your Power Macintosh.
2. For your computer to properly recognize a
new hard drive, you will need to initialize it.
Refer to Chapter 6, "Hard Drive Initializing" for
further instructions.
access port cover
Figure 8; Figura 8
Tempo
Figure 9; Figura 9
Ultra ATA66 cable
Figure 10; Figura 10
expansion card cover
Ultra ATA66 cable
Figure 11; Figura 11
3-4