Denon DVD-A11 Instrucciones De Operación página 9

(5) Connecting a basic 5.1-channel surround system
Analog 5.1-channel audio signals can be output from the DVD-A11.
The multichannel audio signals recorded in packed PCM and the multichannel Super audio CDs can be played
when an AV amplifier equipped with analog 5.1-channel audio inputs is connected.
DVD-A11
Front speaker (left)
Sur ound speaker (left)
AV amplifier w th 5 1-channel
NOTES:
• For multi-channel connections, set "AUDIO CHANNEL" under "AUDIO SETUP" at "SETUP" to "MULTI
CHANNEL" and make the "SPEAKER CONFIGURATION", "CHANNEL LEVEL" and "DELAY TIME" settings.
(See pages 19, 20.)
• With the DVD-A11, we recommend turning the digital output off and only outputting analog signals in order
to keep interference from the digital output circuitry to the minimum and allow you to enjoy high bit, high
sampling frequency, high quality multi-channel sound.
To power outlet
Center speaker
Front speaker (right)
Subwoofer
Sur ound speaker (right)
input terminals
(6) Connecting to a Digital Recorder (MD Recorder, DAT Deck, etc.)
✽ Set the "AUDIO SETUP" default setting as shown below. (See page 20.)
• "DIGITAL OUT" → "PCM"
"LPCM (44.1 kHz / 48 kHz)" → "ON"
Playing DVDs with incorrect settings may result noise that could damage your ears or the speakers.
DVD-A11
NOTE:
• Digital audio signals cannot be output when playing Super Audio CDs. Use analog connections to record
Super Audio CDs.
(7) Connecting to a Stereo Component
DVD-A11
NOTE:
• When connecting to a 2-channel audio stereo device, set "AUDIO CHANNEL" under "AUDIO SETUP" at
"SETUP" to "2 CHANNEL" (see page 19). For multi-channel sources, the signals are down-mixed into two
channels (analog).
(Only the front left and right channels are output for sources for which down-mixing is prohibited.)
Digital audio input
connector OPTICAL)
Optical f ber cable (commercially available)
(or)
75 Ω/ohms pin-plug cable (commercially available)
Stereo component
ENGLISH
Digital audio
input
connector
COAXIAL)
9