Assembly Preparation; Assembly Instructions; Installing The Bottom Shelf - Pit Boss AUSTIN XL Serie Instrucciones De Montaje Y Funcionamiento

Parts are located throughout the shipping carton, including underneath the grill. Inspect the grill, parts, and hardware blister pack after
removing from the protective shipping carton. Discard all packaging materials from inside and outside of the grill before assembly, then
review and inspect all parts by referencing the parts list. If any part is missing or damaged, do not attempt to assemble. Shipping damage
is not covered under warranty. Contact your dealer or Pit Boss Customer Service for parts: Monday through Sunday, 4am - 8pm PST (EN/
FR/ES).
service@pitboss-grills.com | Toll-Free: 1-877-303-3134 | Toll-Free Fax: 1-877-303-3135
IMPORTANT: To ease installation and avoid injury, use two people when assembling this appliance.
Tools required for assembly: screwdriver and level. Tools not included.
IMPORTANT: It is advised to read each step entirely before starting assembly on instructions. Do not tighten screws completely
until all screws for that step have been installed. Hardware combination involving a locking washer and washer should be
installed with the locking washer closest to the head of the screw.

1. INSTALLING THE BOTTOM SHELF

Parts Required:
Support Leg Foot (#14)
2 x
2 x Support Leg for Locking Caster Wheel (#15)
2 x Support Leg for Wheel (#16)
1 x Bottom Shelf (#22)
4 x Screw (#A)
Locking Washer (#C)
4 x
Washer (#B)
4 x
6 x Screw (#G)
Installation:
• Secure one support leg foot to the bottom of a support leg for locking
caster wheel using three screws. Repeat installation for other support leg
foot. Next, place a piece of cardboard on the floor to prevent scratching
the unit and parts during assembly. Prepare the four support legs for
installation, arranging the labeled legs as shown in illustration 1A.
IMPORTANT: The four support legs must be arranged correctly to be able
to properly install the cart support plates in a later step.
• Attach the bottom shelf to one support leg by carefully aligning it into
the slotted corner of the support leg, then secure using one screw. Repeat
installation for the other three support legs to the remaining three corners
of the bottom shelf. Note illustration 1B.
NOTE: Ensure the flat surface of the bottom shelf is facing up.
• Once the shelf is secure, lift the cart frame into an upright position.

ASSEMBLY PREPARATION

ASSEMBLY INSTRUCTIONS

1A
15-2
15-1
16-1
1B
15-2
15-1
A C B 16-1
16-2
16-2
7