Securing The Lid Stopper; Assembling The Lid Handle; Installing The Thermometer - Pit Boss AUSTIN XL Serie Instrucciones De Montaje Y Funcionamiento

person lifting from the opposing barrel end, carefully lift the main grill, and
slowly lower onto the cart. Note illustration 4A.
• Next, open the main grill lid and remove the four screws in the center of
the large diffuser plate. Remove from main barrel and set aside. Adjust the
rotation as needed to align the screw holes of the main barrel to the cart.
Once placed, secure each leg to the main grill barrel using three screws.
Note illustration 4B.
NOTE: When aligned properly, the main grill should be sitting level and
secure on the cart.
• Replace large diffuser plate in main barrel, and secure using previously
removed four screws. Note illustration 4C.

5. SECURING THE LID STOPPER

Parts Required:
1 x Lid Stopper (#11)
Installation:
• Secure the lid stopper onto the top of the main barrel using the pre-
installed screw on the top of the main barrel.

6. ASSEMBLING THE LID HANDLE

Parts Required:
Lid Handle (#7)
1 x
2 x Lid Handle Bezel (#6)
Installation:
• Remove the pre-installed screws from the lid handle. From inside the barrel
lid, insert one screw to protrude to the outside. Add a bezel on the screw,
then hand-tighten the screw (from the inside) into the lid handle. Repeat
for the other side.

7. INSTALLING THE THERMOMETER

Parts Required:
1 x Thermometer Kit (#10)
Installation:
• Remove the pre-installed nut from the thermometer.
• Insert the thermometer into the hole provided on the top of the lid on the
main barrel, then secure by re-installing the nut from the inside. Rotate the
thermometer so the text is level and upright.
NOTE: If rotation is askew, this will result in incorrect readings.
4B
A C B
4C
5
6
7
9