HOW TO USE YOUR BACKPACK SPRAYER
If you have any problems operating your backpack sprayer,
please call Briggs and Stratton on 1800 743 4115 or visit
briggsandstratton.com
Apply chemical diluted liquid
WARNING CHEMICAL BURN HAZARD.
Chemicals could cause burns resulting
in death, serious injury and/or property
damage.
• DO NOT use caustic liquid with backpack sprayer.
• Use ONLY agricultural safe chemicals. Follow all
manufacturers instructions.
• Always wearing safety glasses, protective clothing, safety
gloves, respiratory protection and substantial footwear.
• Wash your hands after handling this product.
• DO NOT drink any liquids from this product.
WARNING RESPIRATION HAZARD.
Some agricultural chemicals could be harmful if
inhaled or ingested, resulting in death, serious
injury, nausea, fainting or poisoning.
Mixing the chemicals/additives should be carried out in a well
ventilated area with adequate lighting. To mix the chemicals/
additives, please refer to chemical manufacturers instructions.
To apply the chemical diluted liquid, follows these steps:
1. Open the sprayer tank lid (A).
2. Fill the chemical dilute liquid into the sprayer tank (C) through
the strainer (B) using an approved filling device or container by
chemical manufacturer. Ensure the chemical dilute liquid inside
the sprayer tank is free from any debris.
3. Once filled, close the tank lid (A) securely.
OPEN
B
C
12
OPERATION
CLOSE
A
ENGLISH
NOTE: DO NOT operate or fill the tank without the strainer
(B). Usage without the strainer will damage and block the
pump. DO NOT dilute additive with dirty water, including water
with organic or synthetic waste that may block the pump.
NOTE:
It is recommended when starting for the first time, the
backpack sprayer should be started with clean water to check for
leaks and correct operation.
WARNING
Avoid contaimination of the environment during mixing and
filling. Any chemical spillages should be cleaned up immediately
to prevent any chemicals from draining into waterways, sewer or
near river. Please refer to chemical manufacturers instructions.
Apply fuel and oil
Mix Fuel and oil
Use the provided bottle and mix gasoline and a high quality
2-cycle oil with at a 25:1 gasoline-to-oil ratio.
Fuel must meet these requirements:
• Clean, fresh, unleaded gasoline
• A minimum of 87 octane/87 AKI (91 RON).
• Gasoline with up to 10% ethanol (gasohol) or up to 15%
MTBE (methyl tertiary butyl ether) is acceptable.
CAUTION
Do not use unapproved gasoline, such as E85. Do not modify
the engine to run on alternate fuels. This will damage the engine
components and void the engine warranty.