Briggs & Stratton 26CC Manual Del Usuario página 18

BACKPACK SPRAYER MAINTENANCE
Clean Debris
Daily or before use, clean accumulated debris from backpack
sprayer. Keep the pump, the sprayer tank, frame and controls
clean. Keep area around and behind the muffler free from any
combustible debris. Inspect cooling air slots and openings on
the backpack sprayer. These openings must be kept clean and
unobstructed.
The backpack sprayer parts should be kept clean to reduce the
risk of overheating and ignition of accumulated debris.
• Use a damp cloth to wipe exterior surfaces clean.
NOTICE Improper treatment of the backpack sprayer can
damage it and/or shorten its life.
• DO NOT insert any objects through cooling slots.
Check & Clean The Sprayer Strainer & Sprayer Tank
Examine the sprayer strainer and sprayer tank. Remove the
sprayer strainer and clean if the screen is clogged with a soft
brush and water. If the screen is damaged, replace it. Clean
the interior of the sprayer tank with a soft brush and rinse it
with water.
Check All Hoses and Fittings For Leaks or Damage
1. The spray hose can develop leaks from wear, kinking, rubbing
or abuse. Inspect the hose each time before using it. Check for
cuts, leaks, abrasions or bulging of cover, damage or movement
of couplings. If any of these conditions exist, replace the hose
immediately.
Warning
Spray hose assembly and fittings are important for safety of the
appliance. NEVER repair this hose. Replace it. Use only hoses
and fitting recommended by the manufacturer.
2. Examine all tubes connection and clean if clogged or replace
if damaged. Examine the hose clamp fittings and retighten if
loose or replace if damaged.
18
ENGLISH
Check The Grease Cups (2 places)
The plunger within the pump needs to be lubricated every 3
hours during operation or as required:
1. Hand turning of the screw cap in clockwise direction until you
feel resistance of the grease starting to inject
2. Then turn one full circle rotation (both screw caps - each side
of the pump). Avoid applying too much grease and may result in
wasted grease leaking from the screw cap. Clean excess grease
from the screw cap as required.
To apply grease
NOTICE Before starting the machine at each use, examine
both the grease cups by opening the screw cap completely
anticlockwise. Refill by hand with No. 3 Lithium grease if
required (approx. 1.5grams each cavity) and replace the screw
cap.
• DO NOT operate the machine without grease.
• DO NOT operate the machine for extrended periods without
applying grease to the plunger.
• DO NOT operate the machine without the grease cup screw
caps assembled.
NOTICE Run the pump without grease can damage the pump
and/or shorten its life.
Grease Cup
hidden in image
below the Screw
Cap
Screw Cap
(2 Places - Both
sides of Pump)