Installing Ultimatte Smart Remote Setup - Blackmagic Design Ultimatte 12 Manual De Instrucciones

Installing Ultimatte Smart Remote Setup

The first step is to download the latest Ultimatte Smart Remote 4 Setup software from the
Blackmagic Design support center at www.blackmagicdesign.com/support. Copy and paste the
Smart Remote .msi file onto a portable USB storage unit, for example a USB flash drive.
Plug the USB drive into the USB port on the front of your Smart Remote 4. Smart Remote 4 will
automatically read the USB drive and open the file explorer.
NOTE The portable storage drive used to install the software on your smart
remote must be formatted as the master boot record using one single
partition. Your Smart Remote 4 recognizes NTFS, exFAT and FAT32 formats.
To install the software:
1 Double tap on the smart remote installer icon in the storage drive.
2 Tap 'next' in the setup wizard and follow the prompts until you reach the 'install' option.
NOTE If you are updating from a previous version of Ultimatte Smart Remote
Setup from the Blackmagic Design support center, you will see 'remove' and
'repair' options. In this case, keep following steps 3 onwards. If updating after
uninstalling SR4 1.0.5, skip to step 9.
3 Select 'remove' to uninstall the smart remote software. Tap 'remove' again
when prompted. A progress bar will briefly appear as the uninstall process begins.
4 When prompted, ensure the radio button labelled 'close the applications
and attempt to restart them' is enabled, and tap 'OK'.
Installing Ultimatte Smart Remote Setup 51