Altotir System Components - Tractel Group altotir 200 Traducción Del Manual Original

4.2 Altotir system components

The altotir™ winch is formed by the following components, shown in Fig. 1.
5
4
GB
19
1) Lifting wire rope
2) Lifting hook
3) Wire rope warping drum.
4) Electric motor
5) Spring-applied brake
6) Electrical unit
7) Fastening crossmembers
8) Tube mounting clamps
9) Limit stop lever
10) Limit stop
11) Carrying handle
12) Base tube
The equipped wire rope is formed by the
lifting wire rope (Fig. 1, item 1), the lifting
hook (Fig. 1, item 2), and the limit stop
(Fig. 1, item 10).
The dimensions indicated on the figures in
this manual are expressed in millimeters
(mm).
22
13
10
18
6
3
11
1
2
13) Clamp fastening studs
14) Clamp fastening nuts.
15) Control unit.
16) Emergency stop button
17) Protective casing
18) Electrical unit access cover
19) Motor compartment access cover
20) Power connector
21) Load up-down control buttons
22) Reduction gear
tested before shipping to 110 % of its
working load limit (WLL) on a lifting height
of 1m, and to 125% of its working load limit
in static utilization mode.
6
14
7
8
16
21
15
NOTE: Each altotir™ winch is
17
9
12
20