Leveling Dishwasher - Signature Kitchen Suite SKSDW2402P Manual Del Propietário

22 INSTALLATION
2
Attach the drain hose to the waste tee with
the hose clamp provided. Move the clamp
into position and tighten it with a flat-blade
screwdriver.
Connecting to Disposal or Waste Tee
with Air Gap
1
Remove the knockout plug with a hammer and
screwdriver.
2
Connect the end of the drain hose
gap with the hose clamp provided. Move
b
the clamp into position and tighten it with a
flat-blade screwdriver.
• This avoids water being siphoned from the
tub.
3
If it is not connected, attach the rubber hose
connector to the disposal or waste tee with a
hose clamp (not provided).

Leveling Dishwasher

Check that the dishwasher is level and adjust the
leveling feet if necessary.
CAUTION
• Failure to level the dishwasher may result in
leakage, problems closing the door, or noise.
• Where the cabinet opening is narrower than
recommended (see Preparing Cabinet
Opening), the dishwasher must be carefully
leveled and aligned so that the dishwasher
is supported fully by the 3 leveling feet and
is not hanging from the installation brackets.
Failure to do so can result in leaks from the
front of the dishwasher, AE errors, difficulty in
closing the door, or failure to operate.
Checking Leveling
To check that the tub is level from front to back,
remove the lower rack and pour 135 oz. (4L)
of water into the bottom of the tub. The water
to the air
a
level should be near the center of both tub lower
indentations at the front.