Signature Kitchen Suite SKSDW2402P Manual Del Propietário página 30

30 OPERATION
Setting the Water Softening Level
For improved wash performance, adjust the water
softening level based on how hard your water is.
The water softener has 5 settings. The default
setting is H2. Follow these steps to check the
setting and adjust it if needed.
1
Press Power and Half Load buttons
simultaneously.
• Current setting shows in display.
2
Press the Remote Start button repeatedly to
set the desired softener level from H0 to H4.
3
Press the Start button to save the setting.
• The power turns off after saving.
NOTE
• The Salt Refill icon turns on in the display if the
dishwasher salt needs to be refilled.
• Setting the softener level to H0 prevents the
Salt Refill icon from turning on even when the
dishwasher salt container is empty.
Filling the Dishwasher Salt
Fill the dishwasher salt container before starting a
wash cycle. If more salt is needed, the Salt Refill
icon will light up on the display, unless the softener
level is set to H0.
CAUTION
• After filling the dishwasher salt container, run
the Rinse cycle immediately to remove any
salt residue from the inner tub and prevent
corrosion.
1
Remove the lower rack and remove the cap of
the salt container located on the left side of the
filters.
2
If you plan to use the water softening system,
you must prime it before using the appliance
for the first time. To do this, mix 2.2 lb (1 kg)
of dishwasher salt with 34 oz (1 liter) of water.
Use the funnel provided to pour the mixture
into the dishwasher salt container. For details
on setting the softener level, see the Before
Using the Appliance section.
3
Tightly close the cover on the dishwasher salt
container.
4
Run the Rinse cycle without dishes.
Salt Refill Frequency
H1 H2
Cycles 200 60
• The table is based on using the Auto cycle.
• Different cycles may use different amounts of
salt.
H3 H4
30 10