Preparing Cabinet Panel - Signature Kitchen Suite SKSDW2402P Manual Del Propietário

2
Use the door adjustment screws provided to
adjust the door spring tension at the bottom of
the dishwasher.
CAUTION
• Tighten the door adjustment screws
completely.
E
• Adjust the spring strength properly. If you do
not adjust the spring strength, the door may
fall open or spring closed unexpectedly.
• Tightening harder than 15 kgf may result in a
crack in the screw boss.

Preparing Cabinet Panel

1
Mark a center line lengthwise down the back
of the cabinet panel.
Max. 15kgf
Y
Y
2
Align the top and center line on the installation
template with the top and center line of the
cabinet panel. Securely tape the installation
template to the back of the cabinet panel.
3
Use a 1/16" (2 mm) diameter drill bit to drill
3/8" (10 mm) deep pilot holes at the 12 points
marked on the template.
4
Remove the template, and attach the upper
and middle panel brackets (provided) to the
cabinet panel using the provided wood screws.
INSTALLATION 25
3/8 "
(10 mm)
Ø 1/16 "
(2 mm)