Securing Cabinet Panel To Dishwasher - Signature Kitchen Suite SKSDW2402P Manual Del Propietário

24 INSTALLATION
Adjusting Rear Leveling Foot
• Use a Phillips screwdriver to adjust the rear
leveling foot and the rear of the tub using the
center screw at the base of the appliance in the
front.
• Turn the center screw clockwise to raise the rear
of the tub and counterclockwise to lower it.
NOTE
• To avoid damaging the screw, do not use an
electric screwdriver.
Securing Cabinet Panel to
Dishwasher
Adjusting Appliance Height
1
Adjust the height of the appliance so the top
of the door is as close to the height of the
surrounding cabinet doors or drawer fronts as
possible.
2
Measure the difference in height (x") between
the top of the dishwasher door and the tops of
the surrounding cabinet doors or drawers.
(m m )
X (m m )
X " In ch
3
Using the measurement from step 2, make a
mark x" up from the bottom of both rulers at
the top of the provided installation template.
Draw a line between the marks and trim off the
top of the template at the line.
Cut out the squares marked on the midline of
the template so that you can see the center
line.
(X mm)
Adjusting Door Spring Tension
If the cabinet panel weighs between 17.6 lb (8 kg)
and 24.2 lb (11 kg), adjust the door spring tension
to make the door easier to open.
17.6 lb (8 kg) ≤
1
Open the dishwasher door to about 30 °.
• Do not adjust the spring strength with the
dishwasher door fully open.
X "
≤ 24.2 lb (11 kg)