Error Codes - Signature Kitchen Suite SKSDW2402P Manual Del Propietário

Problem
Codes starting with n,
U, d, or t appear in the
display.
L0, L1, L2, L3 or L4
appears in display.
H0, H1, H2, H3 or H4
appears in display.
CL appears in display.

Error Codes

Problem Possible Cause
IE
Water inlet problem.
Drainage Problem.
OE
Air gap or disposal is
clogged.
Filters are clogged.
bE
Oversudsing caused by
improper detergent, such
as liquid dish soap
Failure to level dishwasher.
AE
Water leakage
Excessive Water supplied.
FE
Heater circuit failure.
HE
Thermistor failure.
tE
Motor trouble
LE
Vario motor trouble
NE
Possible Cause
Test mode is selected.
Rinse Aid Level setting
mode is selected.
Softener Hardness Level
setting mode is selected.
Control Lock is activated.
• Check for a clogged, kinked or frozen water inlet hose.
• Check water supply.
• Check for a clogged, kinked or frozen water drain hose.
• Clean air gap or disposal.
• Clean Filters.
• Do not use hand dishwashing liquids.Only use
detergents which are designed for use in automatic
dishwashers.
• To remove detergent residue in the tub, pour
approximately 4-8 oz (100~200 mℓ) of milk into a
shallow bowl, place it in the upper rack and then run
the appliance on the Auto cycle.
• Make sure that the appliance is properly leveled.
• Turn off the water supply to the dishwasher and
call a SIGNATURE KITCHEN SUITE Customer
Information Center at 1-855-790-6655 (U.S.A.) or
1-888-289-2802(Canada).
• The dishwasher makes an alert sound for 10 seconds,
and runs the drain pump intermittently. If power is
turned off to the machine, the machine powers back on
automatically until the AE error is resolved.
• Please call an SIGNATURE KITCHEN SUITE
Customer Information Center at 1-855-790-6655
(U.S.A.) 1-888-289-2802(Canada).
TROUBLESHOOTING
Solutions
• This is not an error code. This code is used
when testing the dishwasher. Power the unit
off and on and the code will disappear.
• This is not an error code. This code indicates
the current rinse aid level. For more
information, refer to the Adding Cleaning
Agents section.
• This is not an error code. This code indicates
the current softener hardness level. For more
information, refer to the Setting the Water
Softening Level section.
• This is not an error code. This code indicates
that the control lock is activated. Press and
hold Delay Start for three seconds.
Solutions
61