Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
General information
Contents
Guarantee, safety
Main statutory instruments
Contents
Guarantee, safety ..............................26
Main statutory instruments ................26
Overview............................................27
Power graphs ....................................28
Burner characteristics........................28
Packaging ..........................................28
See technical data N° 13013501
Assembly ...........................................29
Gas connection .................................30
Electrical connection..........................30
Fuel oil connection ............................31
leakage test .......................................32
Settings ....................................32 to 39
Control panel TC ...............................42
Fuel oil firing......................................43
Settings of the fuel oil pressure ........44
Settings device check-up ..................44
Gas firing ...........................................45
Maintenance .....................................46
Maintenance gas .............................47
Maintenance fuel oil........................48
26
Guarantee
Installation and start up must be
performed in accordance with current
accepted practices by a technician.
Current regulations , as well as the
following instructions must be complied
with. Any failure, however minor, to
observe these provisions shall absolve
the manufacturer from any liability.
Also see:
guarantee enclosed with burner,
-
conditions of sale.
-
Safety
The burner is designed to be installed
on a generator connected to exhaust
pipes used for combustion products in
working conditions.
It should be used in an area where an
adequate supply of fresh air is available
for correct combustion and where any
vitiated products can be properly
evacuated.
Flue size and design mut be
appropriate to the fuel, in accordance
with current regulations and standards.
+10
%
Power supply (230VAC
-15
the control and safety unit, as well as to
cut-off devices used, must include an
earthed neutral wire.
Otherwise, power supply to the burner
must include an isolating transformer
and appropriate protection (30mA
circuit breaker and fuse).
Burner must be able to be isolated from
the system via a multipole switch
complying with current standards.
Operating staff should always act with
extreme caution and especially avoid
direct contact with areas that are not
heat-insulated and electrical circuits.
Do not splash water on the burner's
electrical components.
In the event of flooding, fire, fuel
leakage or any other dangerous
situation (smell, suspicious sounds,
etc.), stop burner, cut main power
supply and fuel supply and call a
technician.
Furnaces and their accessories, flues
and connection pipes must be
maintained, cleaned, and swept at least
once a year and prior to starting up
burner. Consult current regulations.
05/2006 - Art. Nr. 13 013 500B
Main statutory instruments "FR"
Dwellings :
French Order dated 2
-
1977 and later modifying /
supplementary orders: Technical and
safety regulations governing
combustible gas and liquified
hydrocarbon installations located
inside dwellings and their
outbuildings.
DTU Standard P 45-204 : Gas
-
installations (formely DTU n° 61-1 -
Gas installations - April 1982 + later
addendums).
DTU Standard 65.4 - Boiler house
-
technical provisions.
French NF Standard C15-100 + Low
-
voltage electrical installation
regulations.
French Departmental health
-
regulations.
Public Buildings :
Public building fire and panic
-
prevention safety regulations.
General provisions :
GZ sections (combustible gas and
-
±1%
50Hz
) to
liquified hydrocarbons);
CH sections (heating, ventilation,
-
cooling, air conditioning and steam
and domestic hot water production);
Provisions specific to each type of
public building.
Outside "FR"
Refer to local regulations.
nd
August
Publicidad
Capítulos
Tabla de contenido
