Harbor Breeze ANIVA BAY Manual Del Usuario página 7

ASSEMBLY INSTRUCTIONS
4. Thread the downrod into the downrod support
of the motor assembly (A). Align the holes in
the downrod support with the holes in the
downrod and re-install the previously removed
clevis pin (Step 1, page 6). Secure clevis pin
with previously removed hairpin clip (Step 1,
page 6). Then, re-install the previously
removed set screws (step 3, page 6) into the
downrod support.
WARNING
It is critical the clevis pin in the downrod support
is properly installed and the set screws are
securely tightened. Failure to do so could result
in the fan falling and causing injury.
5. Route motor coupling cover (F), canopy screw
cover (E) and ceiling canopy (D) over fixture
wires from motor assembly (A).
6. Re-attach the pin previously removed (Step 2,
page 6) into the downrod, then align the
hanger ball so the pin is captured in the
against the pin, then tighten the preassembled
set screw in hanger ball.
CAUTION
A loose set screw could result in a wobbly fan.
4
A
5
D
A
6
C
7
C
Set screw
E
F