Preparation; Initial Installation - Harbor Breeze POINT BREAK Manual Del Usuario

PREPARATION

1. Before beginning assembly and installation of product, make sure all parts are present. Compare parts with
"Package Contents" list and diagrams on the previous page. If any part is missing or damaged, do not attempt to
assemble, install or operate the product. Contact customer service for replacement parts as indicated at the bottom
of page 4.
Estimated Assembly Time: 120 minutes
Tools Required for Assembly (not included): electrical tape, Phillips screwdriver, pliers, safety glasses, stepladder
and wire strippers
Helpful Tools (not included): AC tester light, tape measure, do-it-yourself-guide and wire cutters
Bulbs Required (not included): 3 candelabra base 40 watt max. bulbs, size CA8 recommended
WARNING: When using an existing outlet box, make sure the box is securely attached to the building
structure and can support the full weight of the fan. Failure to do this can result in serious injury or death.
2. After opening top of carton, remove mounting hardware package from foam inserts. Remove motor from packing
and place on carpet or on foam to avoid damage to finish.
CAUTION: Carefully check all screws, bolts and nuts on fan motor assembly to ensure that they are secured.

INITIAL INSTALLATION

1. Turn off circuit breakers and wall switch to the fan supply line
leads. [Fig. 1]
Warning: Failure to disconnect power supply prior to
installation may result in serious injury or death.
2. Determine mounting method to use. [Fig. 2]
A. Normal mount
B. Angle mount
Important: If using the angle mount, check to make sure the
ceiling angle is not steeper than 25°.
3. Check to make sure blades (H) are at least 30 in. from any
obstruction. Check downrod (A) length to ensure blades (H) are at
least 7 ft. above the floor. [Fig. 3]
4. Secure mounting bracket (C) to outlet box using screws, spring
washers, and flat washers (size 8) provided with the outlet box.
[Fig. 4]
*Note: It is very important that you use the proper hardware when
installing the mounting bracket (C) as this will support the fan.
Please make certain that you purchase any hardware that is
missing in order to install the mounting bracket (C) properly.
Important: If using the angle mount, make sure open end of
mounting bracket (C) is installed facing the higher point of the
ceiling.
5 Remove motor screws (L) and lock washers (N) from underside
of motor. If necessary, discard plastic pieces. [Fig. 5]
5
Fig. 1
A
Fig. 2
B
H
30 in.
min.
7 ft.
min.
Fig. 3
C
Fig. 4
Fig. 5
L
N
E