Cleaning The Exterior; Painted Surfaces; Stainless Steel Surfaces - Signature Kitchen Suite SKSCV3002S Manual Del Propietário

64 MAINTENANCE
8
Clean the oven cavity immediately after the
SpeedClean™ cycle by scrubbing with a wet,
non-scratch scouring sponge or pad. (The
scouring side will not scratch the finish.) Some
water may spill into the bottom vents while
cleaning, but it will be captured in
a pan under the oven cavity and
will not hurt the burner.
NOTE
DO NOT use any steel scouring pads, abrasive
pads or cleaners as these materials can
permanently damage the oven surface.
9
Once the oven cavity is cleaned, wipe any
excess water with a clean dry towel. Replace
racks and any other accessories.
10
If some light soils remain, repeat the above
steps, making sure to thoroughly soak the
soiled areas. If stubborn soils remain after
multiple SpeedClean™ cycles, run the Self
Clean cycle. Be sure that the oven cavity is
empty of oven racks and other accessories,
and that the oven cavity surface is dry before
running the Self Clean cycle. Consult the Self
Clean section for further details.
NOTE
• The cavity gasket may be wet when the
SpeedClean™ cycle finishes. This is normal.
Do not clean the gasket.
• If mineral deposits remain on the oven bottom
after cleaning, use a cloth or sponge soaked in
vinegar to remove them.

Cleaning the Exterior

Painted Surfaces

For general cleaning, use a cloth with hot soapy
water. For more difficult soils and built-up grease,
apply a liquid detergent directly onto the soil. Leave it
on for 30 to 60 minutes. Rinse with a damp cloth and
dry. Do not use abrasive cleaners.

Stainless Steel Surfaces

To avoid scratches, do not use steel wool pads.
1
Place a small amount of stainless steel
appliance cleaner or polish on a damp cloth or
paper towel.
2
Clean a small area, rubbing with the grain of the
stainless steel if applicable.
3
Dry and buff with a clean, dry paper towel or soft
cloth.
4
Repeat as necessary.
NOTE
• Do not use a steel wool pad. it will scratch the
surface.
• To clean the stainless steel surface, use warm
sudsy water or a stainless steel cleaner or
polish.
• Always wipe in the direction of the metal
surface finish.
• Stainless steel appliance cleaner or polish can
be purchased online or from most retailers of
appliances or home goods.