Signature Kitchen Suite SKSCV3002S Manual Del Propietário página 70

70 TROUBLESHOOTING
My oven is still dirty after running the
SpeedClean™ cycle. What else should I do?
The SpeedClean™ cycle only helps to loosen light
soils in your oven to assist in hand-cleaning of your
oven. It does not automatically remove all soils after
the cycle. Some scrubbing of your oven is required
after running the SpeedClean™ cycle.
I tried scrubbing my oven after running
SpeedClean™, but some soils still remain. What
can I do?
The SpeedClean™ feature works best when the
soils are fully soaked and submerged in water before
running the cycle and during hand-cleaning. If soils
are not sufficiently soaked in water, it can negatively
affect the cleaning performance. Repeat the
SpeedClean™ process using sufficient water.
Sugar-based and certain greasy soils are especially
hard to clean. If some stubborn soils remain, use the
Self Clean feature to thoroughly clean your oven.
Soil on the oven walls is not coming off. How can
I clean the oven walls?
Soils on the side and rear walls of your oven may be
more difficult to fully soak with water. Try repeating
the SpeedClean™ process with more than the ¼ cup
(2 oz or 60 ml).
Will SpeedClean™ get all of the soils and stains
out completely?
It depends on the soil type. Sugar-based and certain
grease stains are especially hard to clean. Also, if
stains are not sufficiently soaked in water, this can
negatively affect cleaning performance. If stubborn
or built-up stains remain, use the Self Clean feature.
Refer to the Self Clean section of your owner's
manual.
Are there any tricks to getting some of the
stubborn soils out?
Scraping the soils with a plastic scraper before
and during hand-cleaning is recommended. Fully
saturating soils with water is also recommended.
However, certain types of soils are harder to clean
than others. For these stubborn soils, the Self Clean
cycle is recommended. Consult the Self Clean section
of your owner's manual for details.
Is it safe for my convection fan, broil burner or
heater element to get wet during SpeedClean™?
Yes. The convection fan, broiler burner or heater
element may get a little wet during cleaning. However,
direct spray onto the broil burner and heater elements
is not necessary because these are self-cleaning
during regular use.
I see smoke coming out of my oven's vents
during SpeedClean™. Is this normal?
This is normal. This is not smoke. It is actually water
vapor (steam) from the water in the oven cavity. As
the oven heats briefly during SpeedClean™, the
water in the cavity evaporates and escapes through
the oven vents.
How often should I use SpeedClean™?
SpeedClean™ can be performed as often as you
wish. SpeedClean™ works best when your oven is
LIGHTLY soiled from such things as LIGHT grease
splatter and small drops of cheese. Please refer to
the SpeedClean™ section in your owner's manual for
more information.
What is required for SpeedClean™?
A plastic scraper, a non-scratch scrubbing pad and a
towel. You should not use abrasive scrubbers such as
heavy-duty scouring pads or steel wool. Except for a
towel, all of the materials you need are included in a
special cleaning kit with your new oven.