Electromagnetic Immunity - ARTROMOT SP3 Instrucciones Para El Uso

9.2 Electromagnetic immunity

Guidance and Manufacturer's Declaration – Electromagnetic Immunity
®
ARTROMOT -SP3 is intended for use in the electromagnetic environment specified below.
It is the responsibility of the customer or user to ensure that the ARTROMOT
is used in such an environment.
Immunity test
Electrostatic
discharge (ESD)
to IEC 61000-4-2
± 6 kV contact
Electrical fast tran-
sient/burst to IEC
61000-4-5 ± 2 kV for
power supply lines
Surges to IEC
61000-4-5
Voltage dips, short
interruptions and
voltage variations on
power supply input
lines to IEC 61000-
4-11
Power frequency
(50/60 Hz) magnetic
field to IEC 61000-
4-8
NOTE: U T is the a.c. mains voltage prior to application of the test level.
IEC 60601-test Compliance level
level
6 kV contact 6 kV contact
e e
8 kV air 8 kV air
e e
2 kV for power
2 kV for power
e
e
supply lines supply lines
1 kV for input/out-
e 1 kV for
e
input/output lines put lines
1 kV differential
1 kV differential
e
e
mode
mode
2 kV common
e 2 kV common
e
mode
mode
< 5% U T
< 5% U T
(> 95% dip in U T )
(> 95% dip in U T )
for ) cycle
for
40% U T
40% U T
(60% dip in U T )
(60% dip in U T ) for
for 5 cycles
5 cycles
70% U T
70% U T
(30% dip in U T ) for
(30% dip in U T ) for
25 cycles
25 cycles
< 5% U T
< 5% U T
(> 95% dip in U T ) (> 95% dip in U T ) for
for 5 s 5 s
3 A/m 3 A/m
70
Electromagnetic
environment - guidance
Floors should be wood,
concrete or ceramic tile.
If floors are covered with
synthetic material, the
relative humidity should
be at least 30%.
Mains power should be that
of a typical commercial or
hospital environment.
Mains power should be that
of a typical commercial or
hospital environment.
Mains power should be
that of a typical commercial
or hospital environment.
)
cycle
If the user of the
ARTROMOT
requires continued opera-
tion during power mains
interruptions, it is recom-
mended that the
ARTROMOT
device be powered from
an uninterruptible power
supply or a battery.
Power frequency magnetic
fields should be at levels
characteristics of a typical
location in a typical commer-
cial or hospital environment.
Portable and mobile RF com-
mu nications equipment are
used no closer to any part of
the ARTROMOT
vice, including cables, than
the recommended separation
distance calculated from the
equation applicable to the
frequency of the transmitter.
®
-SP3 device
®
-SP3 device
®
-SP3
®
-SP3 de-