Cuppone Giotto GT 110 Guia De Inicio Rapido página 37

Utilizzo
Use
During preheating, the flue gas discharge valve must
kept closed
to prevent heat escaping from the chamber and
the heating elements being turned on with the consequent
overheating of the refractory surfaces which would cause the products
to burn.
It is possible to set the preheating in two ways:
Fig.20. manually
• entering the
temperatures, the top and bottom powers
The entered parameters cannot be stored, so they need to be reset every
time. To avoid this operation, it is necessary to create a recipe
explanations on how to set a recipe, consult the digital full manual.
Fig.21. starting a recipe (program) already
•
saved by the user.
Entering the recipe parameters manually
A
Touching the corresponding field, set:
top power (percentage) (A);
•
Temperature in the cooking chamber (B);
•
bottom temperature (C);
•
bottom power (percentage) (D)
•
turntable revolution settings (E).
• and, if necessary, the
B An alphanumeric keypad will appear on which the desired value
can be entered.
C Confirm with "OK". After setting these parameters, the oven starts
heating straight away in compliance with the set parameters.
During cooking or preheating, if the current temperature in the chamber
is:
• lower than the one set (so the elements are active)
identifying the top and bottom are red.
• equal to or higher than the set one (so the elements are off ),
icons identifying the top and bottom are white.
If the displayed bottom temperature (e.g. 210°C) is
210
higher than the set temperature (e.g. 150°C) but the
SET 150°C
icons are white (elements off ), it means that the
probe that detects the bottom temperature is
5
affected by the accumulation of heat due to the
oven heating. In this case, normally there are no
cooking problems.
Using an already stored recipe
A1
Press the program key or touch the name area
Touch the mane of the recipe
heating up straight away with the parameters set for that recipe; if
you wish, you can modify the parameters of the chosen recipe (e.g.
change the temperature) as usual: the changes made will apply
to the preheating in progress
(temporary effect).
C - Starting cooking
Fig.22.
Once preheating is complete, you can start cooking and bake the
products using personal protection equipment (e.g. gloves) and tools
suitable for contact with food and made of material resistant to high
temperatures (e.g. steel).
For optimal results, always adhere to the oven capacity declared
by the Manufacturer and position the products to be cooked
evenly in the cooking chamber.
During cooking, it is always possible to change any value (e.g.
temperature or turntable rotation) by acting as usual.
Fig.23.
The hood can also be checked and set from the cooking window (light
on/off and suction speed setting).
Ed. 1020 - 70702563 REV00 Giotto Oven - Quick Guide
Utilisation
Benutzung
always be
chamber and bottom
desired.
stored, previously
Fig.20.
the icons
Fig.21.
A2
;
B
you want to use: the oven starts
and will not modify the original recipe
Uso
Эксплуатация
D - Activating an end-of-cooking signal (buzzer)
Fig.24.
If you wish, you can enable a buzzer that will go off when the set time
expires, warning that cooking is complete.
A To activate it, press the
B an alphanumeric keypad will appear on which the desired value
can be entered (in minutes: seconds);
C confirm with "OK".
after how much time the buzzer will go off
The display shows
for
(e.g. 3:10 that is three minutes and ten seconds).
After setting it, the countdown starts, at the end of which a buzzer will
sound to highlight the end of cooking.
To stop the buzzer, press the buzzer key.
the oven continues heating
Warning!
off!
E - Switching the light on (optional)
Fig.25.
If necessary, the cooking chamber light can be switched on. Press the
same key to switch it off.
F - Switching the oven off
Fig.26.
To stop cooking, press the ON/OFF key: the oven goes into stand-by
mode.
Setting the correct language, date and
time
the
Fig.27. In this section, the language as well as the current date
and time can be set.
In the bottom part of the page, you can set the
change to summer time, choosing the Europe or United States
version.
• Europe: summer time starts the last Sunday in March at 2:00
a.m., winter time starts the last Sunday in October at 3:00 a.m.
United States
•
: summer time starts the second Sunday in March at
2:00 a.m.; winter time starts the first Sunday in November at 2:00 a.m.
only
37
key on the display;
when the buzzer goes
automatic