Viewing Individual Values Performed In Triple Bp Measurement Mode; Clearing The Memory; Battery Indicator And Battery Pack Charge; Low Or Empty Battery Pack - Riester RBP-100 Manual Del Usuario

6.2 VIEWING INDIVIDUAL VALUES PERFORMED IN TRIPLE
BP MEASUREMENT MODE
6.2.1 Press the plus button (5) for at least 3 seconds while the device is in standby-mode until
a short beep appears.
6.2.2 The device will now show you each single measurement result with the operation of
measurement 1, measurement 2 and measurement 3.
Note:
- The bottom hand section of the display shows with "N= "1, 2 or 3 which of the 3
measurements is currently shown.
- Individual BP readings of triple BP measurements are not stored individually in the memory.
Only the average is stored.
- Individual BP readings of triple BP measurements are erased when a new triple BP
measurement is performed.

6.3 CLEARING THE MEMORY

6.3.1 Press the Plus button (5) to enter the memory.
6.3.2 Press and hold the SET button (4) for more than 5 seconds until "M" (24) and "CL"
appears on the display.
6.3.3 Confirm clearing the memory by pressing again the SET button. "CL" starts to flash while
the memory is being deleted.
Note:
- Cancel deletion: press the Start/Stop button (3) while «CL» is flashing.

7. BATTERY INDICATOR AND BATTERY PACK CHARGE

7.1 LOW OR EMPTY BATTERY PACK

The device features a built-in, rechargeable NIMH battery pack that devlisers up to 1000
measurement cycles. The battery can be reacharged between uses with the power adaptor
provided. Battery charging indicator is displayed when the rechargeable battery is being
charged.
When the battery pack is approximately ¾ empty the battery symbol (32) appears (partly filled
battery displayed). Although the device will continue to measure reliably, you should obtain to
charge the device soon.
RBP-100