EdmoLift AL Manual De Productos página 200

EdmoLift Products Manual
Mechanical construction Tilts
EdmoLift tilts will tilt loads with capacities from 6KNm to18KNm.
The mechanism comprises upper and lower tilt frames. They are mechanically connected to each other at the tilt joints
and crossmembers.
The tilt force is created by single or double acting cylinders. Every cylinder has an integral hose break valve which
limits the lowering speed to a maximum of 50% over the normally permitted lowering speed in the event of a hose
burst, for example. There is also a constant flow valve in the power pack valve unit which, on leaving the factory, is
set at a suitable lowering speed of approximately 100mm/s.
5
6
1
1
Power pack
2
Bearing kit
3
Tilt cylinder
4
Hydr. hose
5
Safety frame
6
Safety frame switch
Copyright © EdmoLift AB 2004-2007
All rights reserved. No part of this publication may be reproduced, stored in a retrie-
54
val system, or transmitted in any form or by any means, electronic, mechanical,
photocopying, recording or otherwise without the permission of the publisher.
4
3
EdmoLift AB
Jägaregatan 11
S-871 42 HÄRNÖSAND, SWEDEN
85921 GB
2005-02-01
2
Tfn. +46 (0)611-83 780
Fax. +46 (0)611-51 15 80
info@edmolift.se