EdmoLift AL Manual De Productos página 213

EdmoLift Products Manual
Fault finding WP Work Positioners
Fault
The motor doesn´t start
No lifting motion.
The platform doesn´t lower
Fault finding TZ Lift Trolleys
Fault
The motor does not start.
No lifting motion.
Copyright © EdmoLift AB 2004-2007
All rights reserved. No part of this publication may be reproduced, stored in a retrie-
val system, or transmitted in any form or by any means, electronic, mechanical,
photocopying, recording or otherwise without the permission of the publisher.
Reason
The main switch is depressed.
The batteries are insufficiently char-
ged.
The fuse has been triggered.
The motor stops due to the motor
protection relay.
Other reason
The main switch is depressed.
Overload protection activated..
Reason
Batteries insufficiently charged.
The relief valve opens.
The lowering valve is not closed.
Other reason.
EdmoLift AB
Jägaregatan 11
S-871 42 HÄRNÖSAND, SWEDEN
2005-02-01
Action
Pull up the mainswitch.
Charge the batteries.
Find reason and restore.
Lifting trolley is overloaded. Remove
excess load..
Contact EdmoLift
Pull up the main switch.
Lifting trolley is overloaded. Remove
the excess load.
Action
Charge the batteries
Lifting Trolley overloaded. Remove the
excess load.
Check that the lowering rod / wire
has not been damaged or if it needs
adjustment.
Contact EdmoLift.
Tfn. +46 (0)611-83 780
Fax. +46 (0)611-51 15 80
info@edmolift.se
85921 GB
67