EdmoLift Products Manual
Mechanical construction WP Work Positioner
Mechanical construction
The WP work positioner comprises a mast, a chassis with wheels, a battery operated power unit and a battery
charger. The lifting force is produced by a battery-powered motor, which lifts the load carrier by means of a lifting
chain.
Maintenance free batteries, 12 V DC, and a charger for connection to 1-phase mains connection, 230 V, (220-240 V),
50 Hz are included.
The rear wheels are fitted with foot-operated brakes. The brakes should be applied to prevent unintentional movement
when handling goods on the load carrier, or when the work positioner is placed on a sloping surface.
Operation
The main switch on WP 65, WP 85, WP 105, WP 155 and WP 205 is manually operated.
Charging light: See table page 9 for details.
Charger cable: To be connected to electric mains 1-phase, 230 V, 50 Hz. The charger automatically controls the
charging current, and is automatically switched off when the batteries are fully recharged.
The batteries are maintenance-free of type "Accu-CF". They are fully enclosed and do not need any
inspection or topping up. They must however be kept dry and clean.
Electrical system
Before connecting the charger to the mains supply check that the voltage conforms to the mains voltage.
Note! A competent electrician must undertake any fault finding.
Unless an alternative option has been agreed, the battery is supplied for connection to single phase/230 V/50 Hz. (For
220-240V).
Battery charger 12 V, 2 A
Each work positioner has an integral charger, with the exception of model WP 200, which has a separate charger.
The charger plug must be connected to a 220/240 V AC socket .
The charger automatically controls the charging current, and is automatically switched off when the batteries are fully
recharged.
Do not operate the work positioner whilst charging is in progress.
Do not forget to take out the plug before using the machine after charging.
Charging should be carried out as often as possible, so always start charging the batteries after each working shift
Copyright © EdmoLift AB 2004-2007
All rights reserved. No part of this publication may be reproduced, stored in a retrie-
56
val system, or transmitted in any form or by any means, electronic, mechanical,
photocopying, recording or otherwise without the permission of the publisher.
2006-04-03
EdmoLift AB
Jägaregatan 11
S-871 42 HÄRNÖSAND, SWEDEN
85921 GB
Tfn. +46 (0)611-83 780
Fax. +46 (0)611-51 15 80
info@edmolift.se