Publicidad
Idiomas disponibles
Idiomas disponibles
EdmoLift Products Manual
Mechanical construction Pallet Lift
Mechanical construction Pallet Lift
Each Pallet Lift consists of a mast, where the lift force is created by a single acting cylinder within the mast.
There is also a constant flow valve in the power pack valve unit which, on leaving the factory, is set at a suitable
lowering speed of approximately 100mm/sec for a full load.
If an alternative lowering speed is required see instructions on page 46 and 47.
TSL
Pallet Lifts with a centre support leg and two transport wheels. Suitable for 1200mm x 800mm euro pallets, the lift fork
can be lowered to 70mm above floor level. The pallet can then be loaded or offloaded with a pallet truck. Moving the
TSL may be facilitated by a transport trolley (accessories). Safety frames (trip bars) beneath the fork prevent the fork
being lowered onto obstacles.
TSE
Static Pallet Lifts with side support legs. Transport wheels not included. Suitable for 1200mm x 1000mm bottom-
boarded pallets, the lift forks can be lowered to 10mm above floor level. The pallet can then be loaded or offloaded
with a pallet truck. Safety frames (trip bars) beneath the outer edges of the forks prevent them from being lowered
onto obstacles.
TSLN
Tilting Pallet Lifts with a centre support leg and two transport wheels. Suitable for 1200mm x 800mm euro pallets, the
lift fork can be lowered to 70mm above floor level. The lift fork can also be tilted sideways up to 40º both right and left.
When tilting it is important to ensure that the machine and load are stable and only to tilt when the area of operation
does not cause danger to persons. Moving the TSLN may be facilitated by a transport trolley (accessories). Safety
frames (trip bars) beneath the outer edges of the forks prevent them from being lowered onto obstacles.
TSL Pillar
The pillar with power pack enables the users to add their own load carrying attachment. It is delivered with a
CE Declaration of Incorporation, NOT a CE Declaration of Conformity. The users must carry out their own risk
assessment, including strength and stability calculations for their technical file. Data relating to the pillar can be
supplied by EdmoLift.
3
1
4
5
2
6
Copyright © EdmoLift AB 2004-2007
All rights reserved. No part of this publication may be reproduced, stored in a retrie-
val system, or transmitted in any form or by any means, electronic, mechanical,
photocopying, recording or otherwise without the permission of the publisher.
2005-02-01
1
Power pack
2
Lift cylinder
3
Tilt cylinder(TSLN)
4
Hydraulic hose
5
Safety frame switch
6
Safety frame
EdmoLift AB
Jägaregatan 11
S-871 42 HÄRNÖSAND, SWEDEN
85921 GB
Tfn. +46 (0)611-83 780
55
Fax. +46 (0)611-51 15 80
info@edmolift.se
Publicidad
