Owner And Operator Obligations; Intended Use; Warranty; Transport And Storage - omisa SPG 2.0 Manual De Instrucciones

and have them repaired or replaced by an authorized service shop
as needed.
• The dust cap of the interface port has to be closed during welding
in order to prevent contaminants and humidity from entering the
enclosure.
• Mains suppliers' wiring regulations, DIN / CE standards, and ap-
plicable national legislation have to be respected.
• Without prior authorization by the manufacturer, modifications
to the product are unacceptable.
Parts Under Power
After opening the enclosure or removing the cover, parts of
it are accessible that may be under power. It may be opened
Caution
exclusively by an authorized service shop.
User's Manual
The User's Manual has to be available at any time on the
site where the product is used. If the User's Manual becomes
incomplete or unreadable, replace it without delay. Feel free
Info
to contact us for assistance.
2.4

Owner and Operator Obligations

• The system may be operated only when observed. Welders must
have been briefed properly on the operation of the system or
must have participated in a dedicated training. The operating/
owning organization engages to check at reasonable intervals
if the system is operated by the welders as intended and under
proper guidelines of occupational safety.
• The system must be operated only when in proper state of repair
and for one of the intended uses. Before welding, the welder is
required to make sure that the state of the system is in order.
The dust cap for the data tranfer interface port has to cover
the port during operation, in order to keep humidity and
contaminations away.
Important
2.5

Intended Use

The data logger is intended exclusively controlling and recording butt-
welding processes with heating element performed with machines
that are compatible with it and can be connected to it.
The notion of intended use also includes:
• Compliance with the instructions in the User's Manual
• Observation of all service and maintenance intervals
All uses other than those mentioned above are not allowed
and will cancel any and all liability or warranty by the manu-
facturer. Unintended use may cause considerable hazards and
Important
material damage.
2.6

Warranty

Warranty claims may be raised only if the conditions for warranty given
in the General Terms and Conditions of Sale and Delivery obtain.
2.7

Transport and Storage

The product ships in a transport case. Store it dry and protected from
humidity in this case.
6
EN
SPG 2.0 User's Manual
O . M . I . S . A . S r l
Via Verga 9/11
20845 Sovico (MB), Italy
Version June 2020