Using Viewweld To View Welding Reports And Print Tags; Downloading The Reports - omisa SPG 2.0 Manual De Instrucciones

Type of Error
Error Build-up Pressure
Error Heat Soak Pressure
Error Joining Pressure
Cooling Stopped
Error Plate Temperature
Process Stopped
4.6

Using ViewWeld to View Welding Reports and Print Tags

The ViewWeld feature offers viewing an abstracted version of the
welding report recorded during the last welding process and print-
ing it as a label tag to be affixed to the joint on the optionally avail-
able tag printer. The ViewWeld abstract shows the report number,
the date and time of the welding and the welding parameters along
with an evaluation of the quality of the joint/welding operation (see
Display 33).
To call the ViewWeld abstract of a welding report, press the ñ key in
the start screen (see Display 3). To print a tag of this operation, press
the START/SET key in the ViewWeld screen.
After the ViewWeld abstract was accessed, it is possible to browse
through all abstracts in memory by pressing the ï and ð cursor
keys.
5

Downloading the Reports

Interface
USB A Interface Port
for connecting USB mass storage media (such as a memory
stick)
The interface port complies with the USB version 2.0 specification (i.e.,
maximum data rate of 480 megabits per second).
Before transferring data, it is highly recommended to switch
the unit off and on again. If this fails to happens, there is
a risk of data transfer failure, or reports in the unit may be
Important
corrupted.
When transferring welding reports to a USB stick, always
be sure to wait until the display shows the "Download fin-
ished" message before you disconnect the USB stick from
Important
the product. If you disconnect it too early, the unit may ask
you whether you want to delete the reports in memory, al-
though they were not properly transferred. In this case, if
you delete the contents of the report memory, the welding
reports would be irrevocably lost and would not be available
elsewhere either.
18
EN
Build-up pressure too high or too low and was not re-adjusted in
time.
Heat-soaking pressure too high and was not re-adjusted in time.
Joining pressure too high or too low and was not re-adjusted in
time.
Operator has stopped the cooling time by pressing the STOP/REST
key.
Heating element temperature is out of tolerance; impossible to
re-adjust the temperature; maybe the ambient temperature was too
low.
The welding process or a process step were stopped by an external
agent.
SPG 2.0 User's Manual
Description
O . M . I . S . A . S r l
Via Verga 9/11
20845 Sovico (MB), Italy
0011 27.05.14 08:25
PE-HD 630mm SDR26.0
No Error
Display 33
Version June 2020