Product Description - 3M DBI SALA 7234034 Manual De Instrucciones

;
Prior to installation and use of this equipment, record the product identification information from the ID label in the
Inspection and Maintenance Log (Table 2) at the back of this manual.
;
Always ensure you are using the latest revision of your 3M instruction manual. Visit the 3M website or contact 3M
Technical Services for updated instruction manuals.

PRODUCT DESCRIPTION:

Figure 1 illustrates the 3M™ DBI-SALA® Single Point Anchor. The Single Point Anchor is a fixed-point anchorage connector for a
personal fall protection system designed to be attached to a supporting structure. The Single Point Anchor may be used for fall
arrest, work positioning, or fall restraint purposes. Model 7234109 may also be used for rescue purposes.
Figure 2 illustrates components of the Single Point Anchor. See Table 1 for Component Specifications.
System Specifications:
Capacity:
Anchorage Strength:
Service Temperature
Anchorage
Connector Breaking
Strength:
Standards:
Dimensions:
Weight:
Component Specifications:
Figure 2
Reference Component
A Bolt
B Rotation Sleeve
C Nylon Washer
D Anchor Eye
E Oversize Washer
F Marking Plate
Table 1 – Specifications
One user with a combined weight (clothing, tools, etc.) of no more than 141 kg (310 lbs).
;
Model 7234109 is rated for one user plus one rescuer per EN 795. Each person must have
a combined weight (clothing, tools, etc.) of no more than 141 kg (310 lbs).
The required Anchorage Strength depends on the application:
Anchorage Structure: The structure to which the Anchorage Connector is mounted must be
capable of sustaining force in the anticipated direction(s) of loading. Each Anchorage Point location
must be capable of sustaining the following values for Fall Arrest applications:
EN 795
ANSI/OSHA
-40°C to 60°C (-40°F to 140°F)
22.2 kN (5,000 lbs)
Minimum Breaking Strength
Each Single Point Anchor model is tested in accordance with some variation of the standards listed
below. See Figure 1 for which standard applies to which Single Point Anchor model.
Applicable Standards
EN 795.2012 (Type A)
OSHA 1926.502, 1910.140
EN 50308
CEN/TS 16415
See Figure 1 for the dimensions of each Single Point Anchor model.
See Figure 1 for the weight of each Single Point Anchor model.
Materials
Stainless Steel
Stainless Steel
Nylon
Stainless Steel
Stainless Steel
Stainless Steel
12 kN (2,700 lb)
22.2 kN (5,000 lb)
Figure 2
Reference Component
G Flat Washer
H Nylon Lock Nut
I Nylon Bush
J Washer
K Gasket
7
Materials
Stainless Steel
Stainless Steel
Nylon
Stainless Steel
EPDM