Publicidad
I Changing the minimum trimming margin (Additional DIP switch function)
(Be sure to turn off the power before changing any of the DIP switch settings. Refer to page 185.)
The minimum trimming margin is set to 2.0 mm (
allowance for the possibility of striking the needle and the fixed edge knife. The minimum trimming margin can be
changed to 1.5 mm (
At this time, the maximum zigzag width will also increase by 0.5 mm in the right-side direction.
DIPSW1-4...OFF
<Example>
Max. zigzag width
(4.5mm)
Zigzag width
3mm
Base line 2.0mm
1. Use the setting positions for DIP switches 2-1 and 2-2 (A – C) inside the control box to set the trimming margin
as shown in the table below, and also replace the fixed edge knife and stopper with the parts for use when the
minimum sewing margin is 1.5 mm. (Refer to pages 149 and 153.)
2. Set DIP switch 1-4 to ON. (Refer to pages 185 and 187.)
DIPSW2-1
DIPSW2-2
OFF
OFF
OFF
ON
ON
OFF
Replacement parts
DIP switch 1-4 setting
The
mark indicates factory default settings.
) by the procedure below.
Min. trimming margin
(2mm)
Trimming margin
2mm
Edge knife position
1626M
Setting
Minimum trimming margin 2.0mm
trimming margin
2.0-4.5mm
A
B
2.0-6.5mm
C
2.0-9.5mm
ABC
Fixed edge knife (S56099-001)
A
Stopper 3R-2
B
Stopper 5R-2
C
Stopper 8R-2
ZE-8570,8580
7. USING THE OPERATION PANEL
7. VERWENDUNG DER BEDIENUNGSTAFEL
7. UTILISATION DU PANNEAU DE COMMANDE
7. USO DEL TABLERO DE CONTROLES
) at the time of shipment from the factory to make
DIPSW1-4...ON
<Example>
Max. zigzag width
Zigzag width
Minimum trimming margin 1.5mm
zigzag width
trimming margin
0-2.5mm
0-4.5mm
0-7.5mm
Fixed edge knife 1.5 (S56360-000)
(S56361-000)
Stopper 3R
(S56362-000)
Stopper 5R
(S56363-000)
Stopper 8
OFF
Min. trimming margin
(1.5mm)
(5mm)
3mm
Trimming margin
1.5mm
Edge knife position
Base line 1.5mm
zigzag width
1.5-4.5mm
0-3.0mm
1.5-6.5mm
0-5.0mm
1.5-9.5mm
0-8.0mm
(S56040-000)
(S56039-000)
(S48073-000)
ON
1518M
84
Publicidad
Capítulos
