Removing Lower Unit; Disassembling Cam Rod - TOHATSU EverRu MX 18E2 Manual De Servicio

Lower Unit
2 2
1
6-14

3) Removing Lower Unit

1 1
1.
2.

4) Disassembling Cam Rod

1.
2
Removal of lower unit does not require removal of
power unit from outboard motor body.
Remove spring pin and disconnect shift rod.
· Disconnect shift rod at upper side of shift rod joint 1.
· Use spring pin tool A2 to remove spring pin.
· Do not reuse removed spring pin.
· To hold lower unit, keep spring pin tool inserted
until the step of removal of lower unit.
Spring pin tool A2 (ø3.0):
P/N. 345-72227-0
Remove lower unit installation nuts, and pull lower unit ass'y
downward to remove.
CAUTION
Hold lower unit while removing it to prevent
it dropping on the floor.
Remove cam rod bushing bolt 1, and take out cam rod 2
from gear case.
GB
2st X18E2 2012