Assembly Of Propeller Shaft Housing - TOHATSU EverRu MX 18E2 Manual De Servicio

Lower Unit
1
3
b
OBM OBM
OBM
GEAR GEAR
GEAR
1
7
8
8
6-26
b
a
GEAR GEAR
2
GEAR
1
4
5
6
GEAR GEAR
GEAR

18) Assembly of Propeller Shaft Housing

1. Use a press to push new roller bearing into propeller shaft
housing to specified depth.
· Install roller bearing with manufacturer's mark
a facing the tool side.
· Screw in roller bearing attachment 2 lightly by
a hand so that no gap is made at driver rod 1.
· Clean roller bearing installation face and apply
gear oil before installation.
Driver Rod 1 :
P/N. 3AC-99702-0
Roller Bearing Attachment 2 :
P/N. 3BA-99710-0
Center Plate 3 :
P/N. 3AC-99701-0
Push In Depth b :
39.0 ± 0.2 mm (1.535 ± 0.008 in)
2. Install oil seal.
Driver Rod 1 :
P/N. 3AC-99702-0
Oil Seal Attachment 2 4 :
P/N. 3AG-99820-0
· Install oil seal with the marking facing tool side.
· Clean oil seal installation face and apply gear
oil before installation.
· Apply grease to lip of oil seal after installing it.
Install bearing 5.
3.
· Install ball bearing with manufacturer's
marking facing attachment side.
· Clean bearing installation face and apply gear
oil before installation.
Driver Rod 1 :
P/N. 3AC-99702-0
Oil Seal Attachment 7 :
P/N. 3UI-99820-0
Use a suitable press 8 to install reverse (C) gear 6.
4.
GB
2st X18E2 2012