22 | ORBEA
If during an activity the battery level is not
visible on Orbea RS Toolbox, the battery lev-
el percentage will be visible again when the
battery level drops by 1%. At that moment,
the EP8 system will communicate the battery
level via ANT Private to the Garmin unit and
the battery level will be displayed.
You can also switch the bicycle off and on
again (keeping your Garmin device on) to re-
set the connection and thus see the battery
level on your Garmin device.
Read how to download and install the Orbea RS Toolbox
section of this manual.
The Shimano SC-E5003 display does not
have ANT Private connectivity, and there-
fore, models equipped with this display can-
not be connected to Garmin devices with
To connect these models to Garmin devices,
replace the original display for the Shimano
SC-EM800 display.
ORBEA RS BATTERIES
540Wh internal battery.
The internal battery on Urrun does not have LEDs to dis-
play the battery level. To know the charge left on the in-
ternal battery, it must be connected to the pedelec system
in order to check the battery level following the methods
described above.
TECHNICAL MANUAL
Range Extender 252Wh.
Press once the main button of the Orbea RS Range
Extender for the remaining battery level to be displayed.
The LED lights will show the remaining charge in 25% in-
crements from right to left.
The Urrun 2022 Range Extender battery is
not compatible with Rise Carbon 2021-2022
models. The Rise Extender for Rise Carbon
2021-2022 models is not compatible with
Urrun 2022.
Kemen, Urrun and Rise Hydro 2022 use the
same Range Extender 252Wh 2022 exter-
nal battery, however, the Range Extender
connection cable length is different for each
frame. Consult the Range Extender section
of this manual.
CHARGING THE BATTERIES
Before using the internal battery or the
charge the batteries.
ORBEA RS 540WH INTERNAL BATTERY
The Urrun Smart Charger is not compatible
with the Rise Carbon 2021-2022 internal
battery or Range Extender.
The Rise Carbon 2021-2022 charger is not
compatible with the Urrun internal battery
or Range Extender.
Kemen, Urrun and Rise Hydro 2022 use the
same Smart Charger.
B LUE PAP ER U RRU N · 2022
To charge the internal battery on Urrun, plug the RS charg-
er into the mains outlet. With the charger not being con-
nected to the bicycle the LED on the charger´s body will
blink in blue.
Open the bicycle charging port cover and connect the
charger aligning the connector correctly. The arrow on
the charger connector must be aligned with the top part
of the charging port.
The charger´s body LED will turn blue for 2 seconds and
then it will start fading in and out cyclically until the bat-
tery is completely charged.
ORBEA | 23
When the battery is fully charged, the charger´s body LED
will light in blue permanently.
100%
If the charger´s LED lights in red when con-
necting the charger to the outlet or during
the charging process, there is a charging
anomaly. Immediately disconnect the char-
ger and read the charger troubleshooting
method in this manual. If the problem per-
sists, contact an authorised dealer.
ERROR!
E N