Orbea BLUE PAPER URRUN 2022 Manual Tecnico página 38

74 | ORBEA
CONNECTING THE HARNESS CABLE
TO THE INTERNAL BATTERY
To connect the RS harness cable to the internal battery,
make sure that the connector pins and tab are posi-
tioned in the correct position and match those of the
internal battery.
Once the cable and battery connectors make contact, turn
the cable locking ring counter-clockwise and press the ca-
ble connector into the battery connector.
When the connection is positive, release the cable locking
ring. It should return to its original position for the connec-
tion to be secure.
TECHNICAL MANUAL
If the locking ring does not return to its original position
after releasing it, the connection is not secured.
You can carefully pull from the cable connector to check
that the cable connector is secured to the internal battery.
Consult the internal battery removal and installation meth-
od in this manual.
B LUE PAP ER U RRU N · 2022
CABLE ROUTING INSIDE THE FRAME MOTOR
HOUSING AND HARNESS CABLE AND POWER
BUTTON REMOVAL
The internal battery connection cable must be guided on
correct motor installation.
To replace the harness cable or the On/Off power button
necessary to remove the motor from the frame.
Read the section on how to remove the internal battery to
know how to remove the motor from the frame to access
the harness cable and the On/Off power button
Speed
sensor
Display
Motor
Lights (option)
On/Off button
Battery
ORBEA | 75
E N
Derailleur
Dropper
seatpost
Rear brake