Connecting The Range Extender To Urrun; Operation Of The Range Extender; Battery Level Visualization - Orbea BLUE PAPER URRUN 2022 Manual Tecnico

94 | O R B EA
CONNECTING THE RANGE EXTENDER
TO URRUN
Turn the safety tabs of the Range Extender cable coun-
ter-clockwise before connecting it to the battery.
Connect the cable to the Range Extender charging port.
Open the bicycle charging port and connect the Range
Extender cable.
To connect the Range Extender to Urrun, a 275mm con-
nection cable must be used.
Turn the cable´s safety tabs clockwise to lock the cable
in place.
To disconnect the Range Extender cable or to remove the
Range Extender from the bicycle to charge it, turn first
the cable´s safety tabs and carefully pull from the cable´s
connector.
T ECHNI CAL M ANUAL
If the bicycle was On when connecting the
Range Extender to the bicycle, the system
will turn itself Off and you will need to turn
the bicycle On again pressing the power but-
ton. This happens so the system can reboot
and recognize the Range Extender as part of
the power system when the bicycle is turned
On again.
If you were recording an activity with Garmin
Connect using Orbea RS Toolbox, this will
have no effect on the data recorded in the
activity. The bicycle data will keep registering
when you start using it again.
Once you turn the bicycle on, the Range Ex-
tender will be operative. It is not necessary to
turn the Range Extender On.
If the Range Extender is disconnected when
the bicycle is On, the bicycle will turn itself
Off and it will be necessary to turn the bicy-
cle back on. This happens so the system can
reboot and recognize the internal battery as
the only current power supply.
B LUE PAP ER U RRU N · 20 22
OPERATION OF
THE RANGE EXTENDER
The Range Extender powers the EP8 RS motor directly.
When using Urrun with a Range Extender connected to the
system, the motor will only draw power from the Range
Extender until the Range Extender is depleted.

BATTERY LEVEL VISUALIZATION

Combined battery level:
When a Range Extender is connected to Urrun, the system
calculates the total capacity of both the Range Extender
and the internal battery (792 Wh) and the remaining bat-
BATTERY BATTERY CHARGE LEVEL
Internal battery RS (540Wh)
Range Extender (252 Wh)
BATTERY BATTERY CHARGE LEVEL
Internal battery RS (540Wh)
Range Extender (252 Wh)
When the Range Extender is connected to the bicycle and
its charge is depleted, the system will show, by means
of the available methods (displays, junction or RS Toolbox)
the available charge in the internal battery only, account-
Read the Checking the Battery Level section on Use of
Urrun chapter of this manual to learn more about the dif-
ferent ways of checking the battery level on Urrun.
When there is no charge left in the Range Extender, the
internal battery will start powering the motor if it had any
charge left.
tery level information for the system will take into account
the charge left on both batteries out of the total 792 Wh
capacity.
SYSTEM CHARGE LEVEL
50% (270Wh)
50%
396 Wh of 792 Wh
50% (126 Wh)
SYSTEM CHARGE LEVEL
100% (540Wh)
84%
666 Wh of 792 Wh
50% (126 Wh)
ing for the capacity of the internal battery alone and not
the internal battery and the Range Extender system total
capacity.
O RBEA | 95
E N